Sony HKCU2040 Operation Manual page 47

CCU
CONFIGURATION
Page name Item
Page No.
<MONITOR 2> LEVEL GATE
C04
GATE-MARKER
MODULATION
MARKER
<I/F SETUP> BOARD
C05
SLOT1
SLOT2
SLOT3
SLOT4
SLOT5
SLOT6
DSUB-15
CHARA/SYNC
REAR PREVIEW
<MIC GAIN> CAM MIC GAIN
C06
<AUDIO OUT> DELAY
C07
AES/EBU OUT
ANALOG OUT
CH1 LEVEL
CH2 LEVEL
Settings
---, 1&2, 1, 2, OFF
Y-LEVEL1 0 to 108%, 49, 61
–99 to 99, –25
Y-LEVEL2 0 to 108%, 74, 108
–99 to 99, –25
---, ON, OFF
–99 to 99, 0
---, ON, OFF
–99 to 99, 0
ON, OFF
4:3, 13:9, 14:9, EU VISTA, VISTA,
CINEMA, FOLLOW DC
FRONT, REAR
BOARD NAME DISPLAY
BOARD NAME DISPLAY
BOARD NAME DISPLAY
BOARD NAME DISPLAY
BOARD NAME DISPLAY
BOARD NAME DISPLAY
MIC-REMOTE, WF-REMOTE
CHARACTER, SYNC
MOMENTARY, TOGGLE
CH1 ---, 20, 30, 40, 50, 60 dB
CH2 ---, 20, 30, 40, 50, 60 dB
0 to 3840FS
MIC 1/2, AES, EBU
MIC 1/2, AES, EBU
0, +4, –20
ADJUST –99 to 99, 0
0, +4, –20
ADJUST –99 to 99, 0
Description
1&2: Displays level gate 1 & 2.
1: Displays level gate 1.
2: Displays level gate 2.
---: Displayed when camera not connected, video
output not set to CAMERA, or video output is set to
CAMERA and GATE MARKER is ON. (Display only)
Sets the level gate 1 minimum and maximum
detection level.
Sets the level gate 1 zebra range.
Sets the level gate 2 minimum and maximum
detection level.
Sets the level gate 2 zebra range.
Sets the gate signal display to ON/OFF.
---: Displayed when a camera is not connected.
Sets the gate signal level.
Sets the 4:3 aspect ratio mask function to ON/OFF
when EDGE CROP is set to ON.
---: Displayed when a camera is not connected.
Sets the mask video level.
Sets the marker signal to ON/OFF.
Selects a superimposed marker signal.
Display only
Detects and displays the boards installed to the
front/rear of the CCU. (Display only)
Sets the output for the MIC REMOTE connector.
(HDCU2500 only)
Sets the output for the CHARACTER/SYNC
connector. (HDCU2500 only)
Selects the REAR PREVIEW output operating
mode.
Sets the microphone gain.
Settings vary depending on microphones.
---: Displayed when a camera is not connected.
(Display only)
Sets the camera's microphone output phase.
Selects the MIC OUT DIGITAL output. (HDCU2000
only)
Selects the MIC OUT ANALOG output.
Sets the AUDIO CH1 output level.
Sets the AUDIO CH2 output level.
47