Sony HKCU2040 Operation Manual page 4

Network TRUNK function
The HDCU2000/2500 can transmit data at up to 1 gigabit
using the network TRUNK function (via the LAN port).
Network-controllable camera peripheral devices connected to
the HDC2000/2500 series camera can communicate with the
HDCU2000/2500-connected network controller, as well as
utilize IP network cameras as sub-cameras. This function
allows for current and future compatibility with a multitude of
applied system configurations.
HD TRUNK function
The new HD TRUNK function uses 3G optical transmission.
HD-SDI-equivalent digital data separate from an HD-SDI
video signal can be sent from an HDC2000/2500 series
camera to the HDCU2000/2500.
Available only when set to single link format.
HD prompter function
The new HD prompter function uses 3G optical transmission.
HD-SDI-equivalent digital data separate from a return video
signal can be sent from the HDCU2000/2500 to an HDC2000/
2500 series camera.
Safety-oriented power supply
The HDCU2000/2500 is designed for safety. When the power
is turned on, a low voltage is supplied at first. Only after it has
been verified that an appropriate camera is attached, the
normal 240 V AC (HDCU2000) or 180 V DC (HDCU2500)
power supply is activated. The power is not supplied unless a
camera is connected via an optoelectric cable.
Also, the HDCU2000/2500 is equipped with an alarm indicator
to warn of open or short circuits in the cable.
Wide range of audio functions
This unit has connectors for two-channel analog audio
outputs, a digital audio output (only for the HDCU2000), and a
program audio input. Further, the HDCU2000/2500 can use an
intercom system with two independent channels, and supports
four-wire and RTS/Clear-Com intercom systems.
For information on support for RTS/Clear-Com systems,
contact a Sony service or sales representative.
Remote control
The level and phases of this unit's output signals can be
controlled remotely by an MSU-1000 series Master Setup
Unit.
Microphone volume control
The camera's microphone volume can be controlled via the
MIC REMOTE connector, MSU, or RCP.
Character monitor signal output
The results of the HDCU2000/2500 self-diagnosis and setup
menu can be obtained with a text display by character signal
output.
Rack mountable
This unit may be installed in a standard EIA 19-inch rack (three
units high). (The HDCU2500 needs the RMM-301 Rack Mount
Adaptor (optional).)
Plug-in unit configuration
Internal printed circuit boards are designed for easy plug-in
and removal, which makes it easy to inspect and maintain the
unit.
4