Panasonic AW-UE100WP Operating Instructions Manual page 120

Web screen configurations (continued)
Subnet(IPv4)
Enter the subnet mask.
Factory settings: 224.0.0.0
<NOTE>
• Address(IPv4) and Subnet(IPv4) clarify the multicast address
ranges randomly selected during multicast transmissions.
• When Address(IPv4) is set to "239.255.0.0" and Subnet(IPv4) is
set to "255.255.0.0", the selection is made randomly in the range
between "239.255.0.0" and "239.255.255.255".
• To use the IP address set in Address(IPv4), set Subnet(IPv4) to
"255.255.255.255".
TTL/HOP Limit
The same as H.264 Multicast TTL/HOPLimit (→ page 115).
Group [Enable, Disable]
Sets whether to use the grouping function when performing NDI
transmission.
Factory settings: Disable
Name
Sets the group name for use when grouping function is used.
Use discovery server
Sets whether to use the discovery server when performing NDI
transmission.
Server address(IPv4)
Sets the IPv4 address of the server when using the discovery
server.
Audio setting screen [Audio]
„ „
Configure audio settings.
<NOTE>
• Images and audio are not synchronized. Therefore, images and audio
may be slightly out of sync.
• The audio may skip depending on the network environment.
z Setting status
„
Audio
Audio
The setting status of audio input is displayed.
Input Type
The setting status of the audio input type is displayed.
Volume Level
The setting status of audio output volume is displayed.
Plugin Power
The setting status of audio plugin power is displayed.
Audio over IP
Audio transmission
The setting status of audio data IP transmission is displayed.
Audio bit rate
The bit rate setting status for audio data via IP transmission is
displayed.
120