Panasonic AW-UE100WP Operating Instructions Manual page 108

Web screen configurations (continued)
OSD Off With R‑Tally [Off, On]
Off or on the function that turns off camera menu, status, crop frame
and other displays when red tally signals are received via commands
or contacts.
When the red tally signal releases, the camera menu display will
return.
Factory settings: Off
OSD Status [Off, On]
Turn the status display during AWB and ABB off/on, or error display
when an error occurs.
Factory settings: Off
Tally
[Disable, Enable]
[Disable] or [Enable] is set here for the function which turns on or
turns off the tally lamp using the tally control signal.
Factory settings: Enable
Tally Brightness [Low, Mid, High]
Adjust the brightness of the tally LED.
Factory settings: Low
Status Lamp
[Disable, Enable]
[Disable] or [Enable] is set here for the status display lamp.
When you want the status display lamp to stay off while this unit is in
operation, set to [Disable].
Factory settings: Enable
<NOTE>
• Even when set to [Disable], the status display lamp may light
up when this unit is starting up, updating firmware, or trouble is
occurring.
External Output
Select the signal type output from the External Output signal lines
(Output1, Output2) of the RS‑422 connector. (→ page 18)
Output1 [Off , R‑Tally, G‑Tally]
*
Output2 [Off , R‑Tally, G‑Tally]
*
Off Signal is not output.
R-Tally The reception status of the red tally signal is output.
G-Tally The reception status of the green tally signal is output.
: Factory settings
*
z Pan/Tilt
„
The setting is confirmed with the [Set] button.
Install Position
[Desktop, Hanging]
[Desktop] or [Hanging] is selected here as the method used to install
the unit.
Desktop Stand-alone installation
Hanging Suspended installation
Factory settings: Desktop
<NOTE>
• When [Hanging] has been selected, the top, bottom, left and right
of the images will be reversed, and up/down/left/right control for
panning and tilting will also be reversed.
Smart Picture Flip
Mode [Off, Auto]
When the tilt becomes the angle set for [Flip Detect Angle], the image
will be flipped in the vertical direction automatically.
Off The picture is not turned upside down.
Auto The picture is automatically turned upside down.
Factory settings: Off
Flip Detect Angle [60deg to 120deg ]
Set the tilt angle at which the image will be flipped in the vertical
direction automatically when [Smart Picture Flip] is set to [Auto].
Factory settings: 90deg
108