Resetting The Lamp Timer - IBM iLC400 User Manual

Note: The lamp module should be oriented as shown below when replacing.
Attention: This product contains a Metal Arc Lamp, which contains Mercury.
Dispose of it as required by local ordinances and regulations.
The USA restricts or prohibits the disposal of some or all lamps containing
mercury in the municipal waste stream. Please visit www.lamprecycle.org for more
information on specific state disposal requirements and recycling facilities.
For users in Connecticut, please call Northeast Lamp Recycling toll-free at
1-888-657-5267 to place an order for the delivery of a kit that includes a box for the
lamp, tape, and a return shipping label.

Resetting the lamp timer

After replacing the lamp, you should reset the lamp hour counter to zero. Please
follow the steps below.
1. Press the Menu button to open the main menu.
2. Press the cursor left/right button to move to the Information menu.
3. Press the cursor up/down button to move down to Lamp Hour Reset.
4. Press Enter to select Lamp Hour Reset.
5. Press the buttons on the remote or on the projector in the following order:
Attention: Lamp Life is a measure of brightness degradation only, and is not a
specification for the time it takes a lamp to fail and cease light output. Lamp Life
is defined as the time it takes for more than 50% of a lamp sample population to
have brightness decrease by approximately 50% of the rated lumens for the
specified lamp. For example, if the defined life of your lamp is 1500 hours and its
brightness is rated at 2650 lumens, then there is a 50% chance that over 1500 hours
of run time, your lamp will have decreased its brightness by 50% to approximately
1325 lumens.
The OSD will show "Please see User Manual..."
Down Arrow, Up Arrow, Left Arrow, Right Arrow. This will confirm the lamp
hour reset.
Appendix A. Maintenance
A-3