Table of Contents
Advertisement
2. Press the Power button when the Power Off?/Press Power again message
Positioning the projector
To determine where to position the projector, consider the size and shape of your
screen, the location of your power outlets, and the distance between the projector
and the rest of your equipment. Following are some general guidelines:
v Position the projector on a flat surface at a right angle to the screen. The
v Position the projector within 2.7 m (9 ft) of your power source and within 1.8 m
v Position the projector the desired distance from the screen. The distance from the
Attention: Ensure that projector air flow is sufficient and not blocked or using
recirculated air. Please also ensure that the projector is not in a confined space.
2-2
IBM C400 PROJECTOR: User's Guide
The projector prepares for shut-down and the Wait a moment message displays,
as shown below. The projector turns off automatically within 5 seconds.
Note: This operation can be cancelled by pressing a button other than the
Power button. Pressing the Power button again will turn off power.
Note: Leave the power cable plugged in for at least 2-5 minutes until the
projector returns to room temperature before placing the projector inside
the soft case. Placing the projector into the case too soon after turning off
the power could cause the projector to overheat.
displays, as shown below.
The projector turns off.
projector must be at least 1.5 m (4.9 ft) from the projection screen.
(6 ft) of your video device (unless you purchase extension cables). To ensure
adequate cable access, do not place the projector within .15 m (6 in.) of a wall or
other object.
lens of the projector to the screen, the zoom setting, and the video format
determine the size of the projected image.
Advertisement
Table of Contents
