Chapter 2. Setting Up The Projector; Starting The Projector; Turning Off The Projector - IBM iLC400 User Manual

Chapter 2. Setting up the projector

This chapter provides information on positioning the projector, connecting a
computer source and displaying and adjusting an image.

Starting the projector

To start the projector, do the following:
1. Connect the power cord to the projector as shown below. Connect the other
2. Remove the lens cover.
3. Attach the input devices.
4. Turn on the connected input devices.
5. Be sure that the Power LED is on (not flashing) amber and then press the
6. If you have connected more than one input device to the projector, toggle the
7. For information on turning off the projector, go to "Turning off the projector."
Attention: Before moving the projector, be sure to power down the projector
normally and disconnect the projector from the main power source. See "Turning
off the projector" for more information on turning off the projector normally.

Turning off the projector

To turn off the projector, do the following:
1. Press the Power button.
© Copyright IBM Corp. 2004
end of the cord to an electrical outlet. The Power and Lamp-ready LEDs turn
on.
Power button to turn on the projector.
The projector display window opens and the projector detects connected
devices. If you connected the projector to an IBM computer, press Fn+F7 on the
computer to switch the display output to the projector. If you connected the
projector to a non-IBM computer, refer to the documentation that came with
your computer for information on how to change the display output.
Attention: Do not look directly into the projection lens when the lamp is
turned on. The bright light might harm your eyes.
Source button to change devices. (DVD and HDTV are supported through the
DVI-I cable connector.)
2-1