Network Setting Menu - IBM iLC400 User Manual

2. Press the cursor left/right button to move to the Information menu.
3. Press the cursor up/down button to move up and down in the Information
The following table shows the options that you will see in the Information menu.

Network Setting menu

To access the Network Setting menu, follow the steps below:
1. Press the Menu button to open the main menu.
2. Press the cursor left/right button to move to the Information men.
3. Press the cursor up/down button to move to Network Setting in the
4. Press the cursor left/right button or the Enter button to select the Network
5-8
IBM C400 PROJECTOR: User's Guide
menu. The Information menu is shown below.
Item
Video Information
Software Version
Lamp Hours
Network DHCP
Network IP Address
Network Setting
Lamp Mode
Lamp Hour Reset
Cancel
Information menu.
Setting menu. An example Network Setting menu is shown below.
Description
Displays the resolution and refresh rate of
the connected video device.
Displays information about the firmware
version information.
Displays lamp hours used information.
Displays Network DHCP status information.
Displays IP address information.
Displays the Network Setting menu.
Toggles between Normal and ECO lamp
modes. ECO mode uses less power but
decreases the lamp brightness
Reset this item after replacing the lamp. For
more information, refer to "Replacing the
projector lamp" on page A-1
Resets Lamp Mode to the default setting.