Gestetner DSm651 Copy Reference Manual page 122

Troubleshooting
Problem
The stamp position is
wrong.
When using Combine,
parts of the image are not
copied.
Order of copies is not cor-
rect.
4
When using Duplex, copy
is made Top/Bottom even
though Left/Right is se-
lected, or copy is made
Left/Right even though
Top/Bottom is selected.
Paper does not output dur-
ing printing with stapling.
❖ ❖ ❖ ❖ Connect Copy
Problem
You cannot staple, punch
or Z-fold.
You get different copy re-
sults from the main and
sub-machines.
112
Causes
The paper orientation is
wrong.
You specified a reproduc-
tion ratio that does not
match the sizes of your
originals and copy paper.
You placed originals in in-
correct order.
You placed originals in the
wrong direction.
If you stop printing while
using the staple function,
papers not stapled during
printing may be left in the
staple unit.
Causes
The main and sub-ma-
chines are not installed
with the same options.
The Copy Quality setting
differ on the two machines.
Solutions
Check the paper orientation and
stamp position.
When you specify a reproduction
ratio using Manual Paper Select
mode, make sure the ratio matches
your originals and the copy paper.
Note
❒ Select the correct reproduction
ratio before using Combine
mode.
When placing a stack of originals in
the ADF, the last page should be at
the bottom.
If you place an original on the expo-
sure glass, start with the first page to
be copied.
Place originals in the correct orien-
tation.
Press the { { { { Reset} } } } key and cancel
copy settings, including stapling.
Solutions
Press [ ] to cancel Connect
Copy.
Set the Copy Quantity.