Gestetner CS213d Copy Reference Manual page 56

Cat2-5_FM.book Page 42 Thursday, December 14, 2000 4:36 PM
Copying
❒ Select one of the following settings or keys:
• [Normal]: normal paper, adhesive labels
• [Thick]: thick paper, post cards, translucent paper
• [Extra Thick]: Heavier than 157g/m
• [OHP]: OHP transparencies
• [Duplex Back]: Copying onto the reverse side of paper that has been already
copied onto. ⇒ P.49 "Copying onto the reverse side of paper".
2
• [Custom Size]: Custom sized paper. ⇒ P.45 "Copying onto custom size paper
with the bypass tray".
❒ When you copy onto OHP transparencies, you can select whether a blank slip
sheet is inserted between OHP transparencies.
❒ When you set several sheets at a time, fan them to get air between them before
loading.
❒ If the copy paper is curled, gently roll it to remove the curl.
❒ When you copy onto OHP transparencies, insert them with the copy side up.
❒ Do not stack copy paper above the limit mark.
❒ If the copy paper is bent, correct it before setting paper in the bypass tray. If
the bent part is not corrected, a paper misfeed might occur.
❒ When the optional sorter stapler is installed, copies made onto thick or OHP
transparencies are not delivered in the proof tray but in the first bin instead.
❒ When setting custom size paper, be sure to set the size after pressing the [Cus-
tom Size] key.
Important
❒ Do not set normal paper in the Extra Thick mode, otherwise a paper misfeed
or other malfunction might occur.
42
Printed Matters
2
, 42 lb