● Inspection and adjustment by disassembly and cleaning (overhaul)
・ P eriodic inspection and adjustment by disassembly and cleaning
(overhaul) is recommended approximately once every 3 to 4 years in order
to maintain optimal performance of the watch for a long time.
According to use conditions, the oil retaining condition of your watch
mechanical parts may deteriorate; abrasion of the parts due to
contamination of oil may advance or delay the time significantly; or the
watch itself may stop.
As the parts such as the gasket may deteriorate, water-resistant
performance may be impaired due to intrusion of perspiration and
moisture.
Please contact the retailer from whom the watch was purchased for
inspection and adjustment by disassembly and cleaning (overhaul). For
replacement of parts, please specify "SEIKO GENUINE PARTS." When
asking for inspection and adjustment by disassembly and cleaning
(overhaul), make sure that the gasket and push pin are also replaced with
new ones.
9
・When your watch is inspected and adjusted by disassembly and cleaning
(overhauled), the movement of your watch may be replaced.
118
Troubleshooting
Problem
Possible cause
After stoppage, the watch
The watch was exposed to less
was charged longer than
intense light.
the duration specified for
"full charge," but it did not
The system inside the watch
start operating.
was unstable.
The watch gains or
The watch was placed in high
loses occasionally.
or low temperatures.
The time is one hour
A city or region where the place
ahead of or behind
of use is not located is set as
the correct time. (1)
the home time city.
10
120
Solution
Charge the watch in an environment
where sufficient light is available,
such as outdoors on a sunny day.
Reset the built-in IC.
For details, refer to "How to
Reset Built-In IC" on P. 122.
Normal accuracy will resume
when the watch returns to
normal temperatures.
If the problem persists, consult
the retailer from whom the
watch was purchased.
Check the home time city currently
set, and reset it.
To show the time of Tokyo, for
example, set TYO (Tokyo) as the home
time city. For details, refer to P. 84.
● Electroluminescent light
T he br ig htness o f the ele ct r oluminesc enc e ( E L ) panel use d f or the built-
in illuminating light will decrease when the battery voltage becomes low. The
brightness of the EL panel will also gradually decrease with the passage of time.
T he br ig htness o f t he E L panel w ill de cr ease by one - half a f ter a tot al o f
approximately 120 hours of lighting. When the brightness of the EL panel becomes
too dark, first charge the watch sufficiently. If it is still too dark after charging
the watch, replace the EL panel. Consult the retailer from whom the watch was
purchased concerning panel replacement. A fee will be charged for replacement.
● Liquid crystal panel
The normal life expectancy for the liquid panel of the watch is approximately
7 years. After that, it may decrease in contrast, becoming difficult to read.
Consult the retailer from whom the watch was purchased concerning panel
replacement. A fee will be charged for replacement.
Problem
Possible cause
The time is one hour
DST (daylight saving time) is
ahead of or behind
set for the home time.
the correct time. (2)
The buttons will not
The amount of power reserve
work.
has reduced to an extremely
The display remains
low level.
blank.
The blur on the watch
Water entered inside the watch
glass persists.
due to a deteriorated gasket or
for any other reason.
9
119
Solution
If the DST mark is shown to the
left of the home time display,
DST is set for the home time.
To return it to the standard
time, turn off the DST setting.
For details, refer to P. 84.
Refer to "Display and amount
of power reserve" on P. 77, and
charge the watch sufficiently.
Consult the retailer from whom
the watch was purchased.
10
121