Preparation Of Chassis - Goldstar WG5005 Owner's Manual

Installation

Preparation of Chassis

1. Insert the guide panels(Type G)
into the guides of the air conditioner
(Type H),Fasten the curtains to the
unit with screws (Type A).
: Use a long screwdriver and
TIP!
installing the screws will be easier.
2. Cut the adhesive-backed seal strip
(Type E) to the window width.
Remove the backing from the seal
strip and attach the seal strip to the
underside of the bottom window.
3. Locating unit in window
Open the window and mark center line
on the center of the inner sill.
4. Attach L bracket
4-1. Install the L brackets behind the
inner window sill, with short side of
bracket as shown. Use the 2 screws
(Type A) provided.
4-2. The bracket helps to hold unit
securely in place. Be sure to place
bracket edge flush against back of
inner sill.
14 Room Air Conditioner
Type A
Type A
Seal Strip
(Type E)
Inner Sill
Inner Sill
Type A
Outer Sill
7.5"
7.5"
Outside
L Bracket
Type A
Inside
Center Line