Remote Controller - Goldstar WG5005 Owner's Manual

Operating Instructions

Remote Controller

CAUTION: The Remote Controller will not function properly if strong
light strikes the sensor window of the air conditioner or if there are
obstacles between the Remote Controller and the air conditioner.
Power
To turn the Set ON, push the button. To turn the Set OFF, push the button again.
This button takes priority over any other buttons.
When you first turn it on, the Set is on the High cool mode and the temp. at 72 F
Temperature Setting
This button controls the room temperature setting in a range between
60 F and 86 F in 1 increments.
Fan Speed
Pressing the Fan Speed button toggles between Low and
High speeds.
On/Off Timer
- Stopping Operation
Each press of the button cycles through the options in this order:
1 Hour 2 Hours 3 Hours 4 Hours 5 Hours 6 Hours 7 Hours
8 Hours 9 Hours 10 Hours 11 Hours 12 Hours CANCLE.
The set temperature will be raised by 2 F after 30 minutes and again
after another 30 minutes.
- Starting Operation
Each press of the button cycles through the options in this order:
1 Hour 2 Hours 3 Hours 4 Hours 5 Hours 6 Hours 7 Hours
8 Hours 9 Hours 10 Hours 11 Hours 12 Hours CANCLE.
Cool/Energy Saver/Fan/Dry
Everytime you push this button, it will toggle between COOL,
ENERGY SAVER, FAN, and DRY.
Energy Saver
The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
How to Insert Batteries
1. Remove the cover from the back of the remote
controller
2. Insert two batteries.
Be sure of the polarity when installing the
batteries.
Be sure that both batteries are new.
3. Re-attach the cover.
18 Room Air Conditioner
Power
Temp
Fan Speed
Timer Mode
Auto
Swing
Do not use rechargeable
batteries. Such batteries
differ from standard dry cells
in shape, dimensions, and
performance.
Remove the batteries from
the remote controller if the air
conditioner is not going to be
used for an extended length
of time.