7.8 The Channel Status Screen
Use the Channel Status screen to scan wireless LAN channel noises and view the results. Click Network
Setting > Wireless > Channel Status. The screen appears as shown. Click Scan to scan the wireless LAN
channels. You can view the results in the Channel Scan Result section.
Note: The Scan button only works when the VMG uses 20MHz for the wireless channel width.
You can go to the
then change the channel width setting in the Bandwidth field.
Figure 44 Network Setting > Wireless > Channel Status
7.9 The MESH Screen
Use this screen to enable or disable Zyxel MESH (Multy Pro). It supports AP steering and Band steering. AP
steering allows wireless clients to roam seamlessly between Multy-Pro-supported devices in your MESH
network by using the same SSID and WiFi password. Also, AP steering helps monitor wireless clients and
drop their connections to optimize the VMG bandwidth when the clients are idle or have a low signal.
When a wireless client is dropped, it has the opportunity to steer to a Multy-Pro-supported device with a
strong signal. Band steering allows dual band wireless clients to steer from one band to another.
A MESH network consists of a controller, the VMG, and a maximum of three Multy-Pro-supported
extenders.
When Multy Pro is enabled:
Chapter 7 Wireless
Network Setting > Wireless >
VMG8825-B Series User's Guide
109
General screen, click the more link, and