Philips SCF334/61 Manual page 22

English
22
Problem
I experience pain when I
use the breast pump
The breast pump is
scratched
The breast pump does
not work and the on/off
button flashes.
I do not feel any suction. Check if you have assembled the breast pump correctly by following the
The pump has too much
suction.
Solution
Stop using the breast pump and consult your breastfeeding advisor. If the
pump does not come away easily from the breast, it may be necessary to
break the vacuum by placing a finger between the breast and Massage
Cushion.
In case of regular use, some light scratching is normal and does not
cause problems. However, if a part of the breast pump becomes badly
scratched or cracks, stop using the breast pump and contact the Philips
Consumer Care Center or visit www.shop.philips.com/service to
obtain a replacement part. Be aware that combinations of detergents,
cleaning products, disinfection solution, softened water and temperature
fluctuations may, under certain circumstances, cause the plastic to crack.
Avoid contact with abrasive or antibacterial detergents as these can
damage the plastic.
First check if you have assembled the breast pump correctly and make
sure that there is no kink in the tube.To prevent interference keep other
electric equipment, like mobile phone or laptop, away from the breast
pump while expressing.If you are using the single electric breast pump
with batteries, replace the batteries according to the instructions in
the user manual.If you are using the breast pump on electrical power,
check to make sure you are using the adapter that was supplied with the
product.If the problem persists, contact the Consumer Care center via
www.philips.com/support.
steps in section 'preparing for use'. Make sure that the silicone tube is
firmly attached to the motor unit and to the cap and diaphragm.
Also make sure that the pump is positioned correctly on the breast to
allow for vacuum to occur. If you still do not feel any suction, please
contact the Consumer Care center via www.philips.com/support.
Follow below guidelines if you experience too much suction with your
breast pump:
- Make sure you only use the Philips Avent Comfort breast pump's parts.
- Make sure you have assembled the comfort breast pump with the
massage cushion: not using the massage cushion can result in too much
vacuum.
- When using a breast pump for the first time, you may experience the
suction level as too high at first. Practicing can help.If the problem
persists, consult your breastfeeding advisor.