Table of Contents
Advertisement
Auto re-connect to iOS device
In
model, select [
enable or disable auto reconnection to iOS devices.
• For details on the auto re-connect function, see
• You can change the settings with TM-m30II Utility and TM Utility for iOS.
Bluetooth Security Settings
For
models, select [
security settings.
When the security settings are changed from "Middle" or "Low" to "High", or vice versa, the link key
(pairing information) is deleted. If the printer is already paired with a terminal, unpair them and then
pair again.
You can change the settings with TM-m30II Utility and TM Utility for iOS/Android.
Security
Low
Pairing is always possible
Middle
Pairing is possible for one minute after turning the printer on
(initial setting)
or after printing the status sheet
High
Pairing is possible for one minute after printing the status
sheet
Pairing method when the security is set to Middle/High (from the printer)
When the security is set to Middle/High and the printer is ready to be paired, perform the following procedure.
1
Load paper in the printer, and then turn it on.
• Make sure no errors have occurred and that the printer is not off-line.
• You cannot pair the printer while the network is starting up immediately after the power is turned
on.
2
Open the roll paper cover, hold down the FEED button (two seconds), and then close
the roll paper cover.
3
A status sheet is printed, and the Bluetooth LED flashes a pattern indicating that pair-
ing is now possible.
• Pairing is possible for one minute after printing the status sheet.
• You can enable pairing also by printing the status sheet by pressing the status sheet button.
Setup] and then select [Auto Re-Connect iOS], you can select whether to
Setup], and then select [Security], and you can change the
Pairing Mode
Chapter 5 Advanced Usage
"Auto Reconnect Feature" on page
Pairing Method
Just Works
Just Works
Numeric Comparison/Passkey Entry
147.
102
Advertisement
Table of Contents
