Network Setup; Configuring The Wired Network - Kyocera Ecosys P3260dn Operation Manual

Installing and Setting up the Machine > Network Setup

Network Setup

Configuring the Wired Network

The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP (IPv4),
TCP/IP (IPv6), NetBEUI, and IPSec. It enables network printing on the Windows, Macintosh, UNIX and other platforms.
Set up TCP/IP (IPv4) to connect to the Windows network.
Configuration Method
Configuring the Connection
from the Operation Panel on
This Machine
Configuring Connections on
the Web Page
Setting the Connection by
Using the Setup Utility of
IB-50
Be sure to connect the network cable before configuring the settings.
Connecting LAN Cable (page 2-7)
For other network settings, refer to the following:
Network (page 8-13)
NOTE
If user login administration is enabled, you can only change the settings by logging in with administrator privileges.
If user login administration is disabled, the user authentication screen appears. Enter a login user name and
password, and select [Login].
The factory default login user name and login password are set as shown below.
Login User Name:
Login Password:
IPv4 setting
1
2
Configuring the wired network settings from System menu.
For the equipped network interface, the connection can be set by
using Command Center RX. For the optional IB-50, the connection
can be set by using the dedicated Web page.
This is the setup tool included in the CD of IB-50. You can use it on
Windows.
6000
6000
Display the screen.
[Menu] key > [▲] [] key >[Network] > [OK] key > [▲] [] key > [Wired Netwk. Set] > [OK] key
> [▲] [] key >[TCP/IP Settings] > [OK] key > [▲] [] key > [IPv4 Setting] > [OK] key
Configure the settings.
When using DHCP server
1
[▲] [] key > [DHCP] > [OK] key > [▲] [] key > [On] > [OK] key
Description
2-16
Reference Page
IPv4 setting (page 2-16)
Command Center RX
User Guide
IB-50 Operation Guide
IB-50 Operation Guide