View Your Trunk Group Status Information - TRENDnet TEG-30102WS User Manual

TRENDnet User's Guide
Click the drop-down list and select one of the following options.

Active - The specific aggregator will broadcast and respond to LACPDU (LACP
Data Unit) packets. This setting enables the dynamic LACP feature for the trunk.

Passive - The specific aggregator will not broadcast LACPDU packets, but it will
respond to them. This setting disables the LACP feature for the trunk

Manual - Enables static port trunking and disables the LACP feature for the
trunk. (Static link aggregation).

Disable - Disables the static port trunk and disables the LACP feature.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2018 TRENDnet. All Rights Reserved.

View your trunk group status information

Bridge > Trunk Config > LACP Group Status
1. Log into your switch management page (see
on page 11).
2. Click on Bridge, click on Trunk Config, and click on LACP Group Status.
3. View your trunk group status information.

System Priority - Preassigned setting that cannot be modified. This value
applies to the switch.

System ID - MAC address value assigned to the individual switch. This value
cannot be modified.

Group: # The ID number of the trunk (link aggregation group).
TEG-30102WS
"Access your switch management page"
32