TRENDnet TEG-30102WS User Manual page 30

TRENDnet User's Guide
Note: When selecting a Mode setting, the following points apply:
o
When a twisted-pair port is set to Auto-Negotiation, the end node should
also be set to Auto-Negotiation to prevent a duplex mode mismatch.
o
A switch port using Auto-Negotiation defaults to half-duplex if it detects
that the end node is not using Auto-Negotiation. This can result in a
mismatch if the end node is operating at a fixed duplex mode of full-duplex.
To avoid this problem when connecting an end node with a fixed duplex
mode of full-duplex to a switch port, disable Auto-Negotiation on the port
and set the port's speed and duplex mode manually.
o
The only valid setting for the SFP ports is Auto-Negotiation.

Jumbo: This parameter indicates whether or not jumbo frames can be accepted
by the switch. You may want to activate jumbo frames when your switch will
transmit video and audio files. The possible values are:
o
Ignore -This parameter indicates that the All setting does not apply to
the Jumbo field. In other words, each port is set individually.
o
Enabled -This parameter indicates the port is permitted to accept
jumbo frames.
o
Disabled -This parameter indicates the port is not permitted to accept
jumbo frames.
Note: When QoS is enabled on a port, the Jumbo frame parameter can not be
enabled.

Flow Ctrl: Flow Control, This parameter reflects the current flow control setting
on the port. The switch uses a special pause packet to notify the end node to
stop transmitting for a specified period of time. The possible values are:
o
Ignore - This parameter indicates that the All setting does not apply to
the Flow Control field. In other words, each port is set individually.
o
Enabled - This parameter indicates that the port is permitted to use
flow control.
o
Disabled - This parameter indicates that the port is not permitted to
use flow control.
© Copyright 2018 TRENDnet. All Rights Reserved.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TEG-30102WS
26