TRENDnet TEG-30102WS User Manual page 7

TRENDnet User's Guide

Diagnostic LED Indicators

Power LED
: When the Power LED lights on, the device is receiving
On
power.
: When the Power turns off or the power cord is not
Off
connected

System LED
Solid - device ready and operating normally.
On (Green) :
Flashing – Firmware upgrade process
Flashing – device is booting up, not ready. Also, will
flash when resetting device to factory default.
Solid – device LED will remain in this state when
resetting to factory default through HW reset button,
On (Orange) : and will turn green after first reboot.
*If the System LED is flashing or on solid (orange)
after normal switch operation, flashing will indicate
an issue with the smart fan, solid will indicate an issue
with switch.
© Copyright 2018 TRENDnet. All Rights Reserved.

2.5G/1G/100M Ports (1-8)

Link/Activity: The upper left LED indicator above the Ethernet port
On (Green) : Solid – Device is connected at 2.5G speed.
Blinking – Data transmission/activity at 2.5G speed.
On (Orange) : Solid – Device is connected at 1G/100Mbps speed.
Blinking – Data transmission/activity at 1G/100Mbps
speed.
Off : No link.

SFP+ Slots (9-10)
On (Green) : Solid - Device is connected at 10G speed.
Blinking – Data transmission/activity at 10G speed.
Off No link
TEG-30102WS
3