Create Dial-In Users (Local Authentication Method) - TRENDnet TEG-30102WS User Manual

TRENDnet User's Guide

Create Dial-In Users (Local Authentication Method)

Security > Dial-in User
Dial-in User feature provides the local authentication server for port security when a
remote (RADIUS) server is not available.
The Dial-in User (local) authentication method allows you to set up 802.1x
authentication parameters internally in the Switch. In this case, the user name and
password combinations are entered with an optional VLAN when they are defined.
Based on these entries, the authentication process of a supplicant is done locally by the
Switch Management Utility using a standard EAPOL (EAP over LAN) transaction.
1. Log into your switch management page (see
on page 11).
2. Click on Security and click on Dial-In User.
3. Review the settings.
To create a dial-in user for local authentication, use the following procedure:

In the User Name field, type a name for the user.

In the Password field, type a password for the user.

In the Dynamic VLAN field, enter the VID of the VLAN which you will allow the
user to access. If you enter 0, this field will be ignored.
Click Add to add the entry to the table.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"
In the list, you can click Modify to modify an entry or click Delete or delete the entry.
You can also click Delete All to delete all of the entries in the table. If the entries span
multiple pages, you can navigate page number in the Page field and click Go or you can
click First, Previous, Next, and Last Page to navigate the pages.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TEG-30102WS
75