Configure Parameters For Rmon Ethernet Statistics - TRENDnet TEG-30102WS User Manual

TRENDnet User's Guide
3. Click the RMON Status drop-down list and select Enabled to enable RMON. Click
Apply to save settings.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.

Configure parameters for RMON Ethernet statistics

RMON > Statistics
You can remotely view individual port statistics with RMON by using your SNMP NMS
software and the RMON portion of the MIB tree.
1. Log into your switch management page (see
on page 11).
2. Click on RMON and click on Statistics.
3. Review the settings.

Index: This parameter specifies the ID number of the new group. The range is 1
to 65535.

Port: This parameter specifies the port where you want to monitor the
statistical information of the Ethernet traffic.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"

Owner: This parameter is used to identify the person who created an entry. It is
primarily intended for switches that are managed by more than one person,
and is an optional field.
Click Add to add the entry to the table.
In the list, you can click Modify to modify an entry or click Delete or delete the entry. If
the entries span multiple pages, you can navigate page number in the Page field and
click Go or you can click First, Previous, Next, and Last Page to navigate the pages.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TEG-30102WS
65