To Load The First Pocket (Separate Laundry Scale) - Milnor 60044SR2 Operator's Manual

Normal Operation
3. On the Weighing System display, touch the button labeled "Compartment 1" to activate the
load cell (scale) in the first pocket (the machine shown in the figure has 2 pockets).
The scale tares to zero and the weight value turns green, as shown below.
CAUTION: People or objects leaning on the machine — can cause inaccurate weight
4. Load the first pocket according to the recommended load size for your goods type. The load
cell weighs the goods as you load the pocket, and the controller displays the current weight in-
side the pocket.
TIP: If you accidentally load the machine before you activate the load cell (Step 3),
remove the goods from the machine, then touch
zero.
5. When you finish loading the pocket, touch the button labeled "Compartment 1" again to con-
firm the weight.
The weight value turns red, as shown below, and the weight can no longer be adjusted.
Continue to Section 3.8 : Close the inner door., page 21
3.7.2

To Load the First Pocket (Separate Laundry Scale)

Use the following instructions to load the first pocket on your divided-cylinder machine if it is
not equipped with the optional weighing system. If your machine is equipped with a weighing
system, see Section 3.7.1 , page
1. Weigh the goods in the batch (with a laundry scale, weighing-type load conveyor, etc).
2. Divide the batch into 2 equal parts if you have a two-pocket machine, or 3 equal parts if you
have a three-pocket machine.
The individual weight of each part should be as close as possible to
where the batch weight is as close as possible to the recommended load size for the type of
goods.
Ex. The recommended load size is 100 kg. If the batch weight is 98 kg, and there are 3 pockets:
20
readings.
Do not lean on the machine.
�
Do not rest heavy objects against the machine.
�
Do not push objects such as laundry carts against the machine.
�
19.
batch weight/# of pockets
. This tares the scale back to
BNWVUO04.T05 0000289654 D.2 C.2 B.3 10/9/20 11:54 AM Released
Pellerin Milnor Corporation