Open The Outer Door (Air Unlatch); Open The Inner Doors; Figure 8 Air-Unlatch Door; Figure 9 Inner Door Weld Dot - Milnor 60044SR2 Operator's Manual

Normal Operation
BNWVUO07 / 2020403
3.5

Open the outer door (air unlatch).

1. With one hand, hold the door unlatch button (
depressed.
The door's air-seal deflates and the plunger latch audibly re-
tracts. The controller will delay retracting the door plunger
long enough to de-pressurize the seal.
2. With the door unlatch button (
other hand to pull the door open.
3. Release the door unlatch button.
3.6

Open the inner doors.

The inner doors access the cylinder pockets. Identify cylinder
pockets by weld dots (1, 2, or 3) on the rim of the inner door, as
shown in Figure 9, page
One weld dot means the inner door accesses pocket 1, two dots
mean the inner door accesses pocket 2, and if your machine is a
three-pocket machine, three dots mean the inner door accesses
pocket 3.
The inner and outer doors must be aligned before it is safe to
open the inner doors. If you open the outer door and the inner
and outer doors are not aligned, close the outer door and use the
AutoSpot™ feature to rotate the cylinder until the doors are
aligned.
Each inner door is made up of three panels that must be opened
individually. Open the panels in the order shown.
16
) still held, use your
16.
BNWVUO07 0000303537 A.9
BNCLJO12.T07 0000289743 D.2 A.9 A.19 9/22/20 4:33 PM Released
)
Figure 8. Air-unlatch Door
BNCLJO12.T06 0000289745 D.2 A.9 A.25 9/22/20 4:43 PM Released
Figure 9. Inner Door Weld
Dot
Figure 10. Inner and Outer
Door Aligned
9/29/20 11:44 AM Released
Pellerin Milnor Corporation