Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
Initial setting (installation setting)
Set [FRONT/REAR] and [FLOOR/CEILING] in [PROJECTION METHOD] depending on the installation mode.
Refer to "Installation mode" ( x page 30) for details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu →
[PROJECTION METHOD].
1)
Press qw to switch the setting.
2)
Press the <ENTER> button to proceed to the initial setting.
Initial setting (standby mode)
Set the operation mode during standby. The factory default setting is [NORMAL], which allows you to use the
network function during standby. To keep power consumption low during standby, set this item to [ECO].
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [ECO
MANAGEMENT] → [STANDBY MODE].
1)
Press qw to switch the setting.
2)
Press the <ENTER> button to proceed to the initial setting.
Note
f The preceding initial setting screen is displayed when the projector is switched on for the first time after purchase. When the [PROJECTOR
SETUP] menu → [INITIALIZE] → [ALL USER DATA] is executed, the [STANDBY MODE] setting before executing is displayed.
Initial setting (screen setting)
Set the screen format (aspect ratio) and display position of the image.
After completed the initial setting, you can change the settings of each item from the [DISPLAY OPTION] menu →
[SCREEN SETTING].
1)
Press qw to switch the setting.
f Proceed to Step 4) when [16:10] is selected.
42 - ENGLISH
INITIAL SETTING
PROJECTION METHOD
FRONT/REAR
FRONT
FLOOR/CEILING
AUTO
Change the projection method
(FRONT/REAR, FLOOR/CEILING)
if the screen display is upside down
or inverted.
MENU SELECT
CHANGE
SET
ENTER
INITIAL SETTING
NORMAL
STANDBY MODE
When set to ECO,
network functions and some RS-232C commands
are not available during standby.
CHANGE
SET
ENTER
2/6
3/6
Advertisement
Chapters
Table of Contents
