Panasonic DLP PT-FRZ60 Operating Instructions (Functional Manual) page 100

f If the projector is operating with [CONSTANT MODE] set to [AUTO] or [PC], brightness and color cannot be measured when the shutter
function is enabled (shutter: closed) within approximately eight minutes after the light source is turned on. Therefore, brightness may be
corrected after approximately 30 seconds have elapsed after the shutter function is disabled (shutter: open).
f If the projector is operating with [CONSTANT MODE] set to [AUTO] or [PC], the brightness and color of the light source do not stabilize for
approximately eight minutes after the light source is turned on. Therefore, the brightness and color of the light source will be automatically
measured after approximately eight minutes have elapsed after the light source is turned on. A correction is made based on this
measurement result so that the brightness and color for the image will be the same as the standard brightness and color when adjusted with
the brightness control.
f If the projector is operating with [CONSTANT MODE] set to [AUTO] or [PC], the items of [OPERATING MODE] and [LIGHT OUTPUT] cannot
be changed.
f The variation in brightness may increase due to dust accumulating on the lens, screen, or inside the projector, depending on the installation
environment of the projector.
f When the variation in brightness has increased due to aging of the light source, or when you replaced the light source, readjust the
brightness control.
f When the projector is used continuously for more than 24 hours, set [CALIBRATION TIME]. If it is not set, correction will not be performed
automatically.
f The brightness control function and the dynamic contrast function will operate simultaneously, but the dynamic contrast function will not
operate while measuring the brightness and the color.
f The [CALIBRATION TIME] setting will be reflected when you enter the time.
f The [CALIBRATION MESSAGE] setting will be reflected at the time when the item is switched using qw .
Displaying [BRIGHTNESS CONTROL STATUS]
Display the brightness control status.
1) Press as to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3) Press as to select [BRIGHTNESS CONTROL STATUS].
4) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL STATUS] screen is displayed.
[BRIGHTNESS CONTROL STATUS] screen display example
When [CONSTANT MODE] is set to [OFF]
The screen shows the status that the brightness control is disabled.
When [CONSTANT MODE] is set to [AUTO], and [LINK] is set to [OFF]
The screen shows the status of the brightness control in one projector.
When [CONSTANT MODE] is set to [AUTO], and [LINK] is set to [GROUP A] through [GROUP D]
The screen shows the status of the brightness control of synchronized projectors (up to eight units), including the
projector being controlled through the on-screen menu.
100 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
BRIGHTNESS CONTROL STATUS
CONSTANT MODE
PROJECTOR
RETURN
MENU
BRIGHTNESS CONTROL STATUS
LINK
PROJECTOR
RETURN
MENU
OFF
1
OFF
5
1
6