Manually Configuring Network Adapters - Belkin G Plus User Manual

to the Internet.
Manually Configuring Network Adapters in Mac OS
up to 9.x
In order for your computer to properly communicate with your Router,
you will need to change your Mac computer's TCP/IP settings to DHCP.
1.
Pull down the Apple menu. Select "Control Panels" and
select "TCP/IP".
2.
You will see the TCP/IP control panel. Select "Ethernet Built-In"
or "Ethernet" in the "Connect via:" drop-down menu (1).
[Use existing screenshot]
(1)
(2)
3.
Next to "Configure" (2), if "Manually" is selected, your Router
will need to be set up for a static IP connection type. Write the
address information in the table below. You will need to enter this
information into the Router.
[Use existing screenshot]
4.
If not already set, at "Configure:", choose "Using DHCP
Server". This will tell the computer to obtain an IP address
from the Router.
[Use existing screenshot]
5.
Close the window. If you made any changes, the following
window will appear. Click "Save".
Restart the computer. When the computer restarts, your network
settings are now configured for use with the Router.
[Use existing screenshot]
Manually Configuring Network Adapters in Mac OS X
1.
Click on the "System Preferences" icon.
[Use existing screenshot]
2.
Select "Network" (1) from the "System Preferences" menu.
[Use existing screenshot]
(1)
3.
Select "Built-in Ethernet" (2) next to "Show" in the
Network menu.
[Use existing screenshot]
(2)
(3)
(4)
4.
Select the "TCP/IP" tab (3). Next to "Configure" (4), you should
see "Manually" or "Using DHCP". If you do not, check the
PPPoE tab (5) to make sure that "Connect using PPPoE" is NOT
selected. If it is, you will need to configure your Router for a
PPPoE connection type using your user name and password.
5.
If "Manually" is selected, your Router will need to be set up
for a static IP connection type. Write the address information
in the table below. You will need to enter this information into
the Router.
[Use existing screenshot]
6.
If not already selected, select "Using DHCP" next to "Configure"
(4), then click "Apply Now".
Your network adapter(s) are now configured for use with the Router.