Belkin G Plus User Manual page 49

The wireless network is often interrupted.
Solution:
1.
Move your wireless PC closer to the Router to find a better signal.
2.
There may also be interference, possibly caused by a microwave
oven or 2.4GHz cordless phones. Change the location of the
Router or use a different wireless channel.
Problem:
I can't connect to the Internet wirelessly.
Solution:
If you are unable to connect to the Internet from a wireless computer,
please check the following items:
1.
Look at the lights on your Router. If you are using a Belkin Router,
the lights should be as follows:
• The "Power" light should be on.
• The "DSL LED"v should be on, and not blinking.
• The "Internet LED" should be either on or blinking.
2.
Open your wireless utility software by clicking on the icon in
the system tray at the bottom right-hand corner of the screen.
If you're using a Belkin Wireless Card, the tray icon should look
like this. The icon may be red or green.
3.
The exact window that opens will vary depending on the model of
wireless card you have; however, any of the utilities should have
a list of "Available Networks"— those wireless networks it can
connect to.
Does the name of your wireless network appear in
the results?
Yes, my network name is listed—go to the troubleshooting
solution titled "I can't connect to the Internet wirelessly, but my
network name is listed".
No, my network name is not listed—go to the troubleshooting
solution titled "I can't connect to the Internet wirelessly, and my
network name is not listed".
Problem:
I can't connect to the Internet wirelessly, but my network name
is listed.
Solution:
If the name of your network is listed in the "Available Networks" list,
please follow the steps below to connect wirelessly:
1.
Click on the correct network name in the "Available
Networks" list.
2.
If the network has security (encryption) enabled, you will need to
enter the network key. For more information regarding security,
see the page entitled: "Changing the Wireless Security Settings".
3.
Within a few seconds, the tray icon in the lower left-hand
corner of your screen should turn green, indication a successful
connection to the network.
Problem:
I can't connect to the Internet wirelessly, and my network name is
not listed.
Solution
If the correct network name is not listed under "Available
Networks" in the wireless utility, please attempt the following
troubleshooting steps:
1.
Temporarily move computer, if possible, five to 10 feet from
the Router. Close the wireless utility, and re-open it. If the
correct network name now appears under "Available Networks",
you may have a range or interference problem. Please see the
suggestions discussed in Appendix B entitled "Important Factors
for Placement and Setup".
2.
Using a computer that is connected to the Router via a network
cable (as opposed to wirelessly), ensure that "Broadcast SSID" is
enabled. This setting is found on the Router's wireless "Channel
and SSID" configuration page.
If you are still unable to access the Internet after completing
these steps, please contact Belkin Technical Support.
Problem: