Belkin G Plus User Manual page 20

Adsl2+ modem with wireless mimo router

Hide thumbs Also See for G Plus:

Table of Contents

[insert 9630_IPoA.tif]

(1)

(2)

(3)

(4)

(5)

1. WAN IP Address –

Enter an IP address assigned by your ISP for

the Router WAN interface.

2. WAN Subnet Mask -

Enter a subnet mask assigned by your ISP.

3. Default Route -

Enter a default gateway IP address. If the Router

cannot find the destination address within its local network, it will

forward the packets to the default gateway assigned by your ISP.

4. VPI/VCI -

Enter your Virtual Path Identifier (VPI) and Virtual Circuit

Identifier (VCI) parameter here. These identifiers are assigned by

your ISP.

5. Encapsulation -

Select LLC or VC MUX your ISP uses.

Setting your Connection Type to Modem Only (Disable

Internet Sharing)

In this mode, the Router simply acts as a bridge passing packets

across the DSL port. It requires additional software to be installed on

your computers in order to access the Internet.

[insert 9630_Modem_Only.tif]

Table of Contents

F5d9630-4