Belkin G Plus User Manual page 29

1.
Select "128-bit WEP" from the drop-down menu.
2.
After selecting your WEP encryption mode, you can enter your
key by typing in the hex key manually.
A hex (hexadecimal) key is a mixture of numbers and letters
from A–F and 0–9. For 128-bit WEP, you need to enter 26 hex
characters.
For instance:
C3 03 0F AF 0F 4B B2 C3 D4 4B C3 D4 E7
[Use existing screenshot]
3.
Click "Apply Changes" to finish. Encryption in the Router is now
set. Each of your computers on your wireless network will now
need to be configured with the same security settings.
WARNING:
If you are configuring the Wireless Router or access point
from a computer with a wireless client, you will lose your connection
until you enable security on your wireless client. Please be sure to
write down your key before applying changes.
(The following paragraph is moved to before WEP settings)
WPA Setup
Note: To use WPA security, all your clients must be upgraded
to drivers and software that support it. At the time of this User
Manual's publication, a security patch download is available free
from Microsoft. This patch works only with the Windows XP operating
system. You also need to download the latest driver for your Belkin
Wireless G Desktop or Notebook Network Card from the Belkin
support site. Other operating systems are not supported at this time.
Microsoft's patch only supports devices with WPA-enabled drivers
such as Belkin 802.11g products.
There are two types of WPA security: WPA-Personal (PSK) and WPA-Enterprise (RADIUS). WPA-Personal (PSK) uses a so-
calledPre-Shared key as the security key. A Pre-Shared key is a password
that is between eight and 63 characters long. It can be a combination
of letters, numbers, and other characters. Each client uses the same
key to access the network. Typically, this mode will be used in a
home environment.
= 128-bit WEP key