Table of Contents
Advertisement
OPERATION
Skip Feed Printing (Skip Feed Mode)
If the back of prints are dirty, you can increase the time between two prints
using the Skip Feed key. In the default setting, when one sheet of paper is
fed the drum rotates once. However, you can select the number of rotations
of the drum. This gives you the chance to remove prints one by one from
the paper delivery table or insert one sheet of paper between two prints. If
you use this function, you can also use paper longer than 447 mm, 17.5" in
spite of the maximum length limitations of paper.
The maximum length of paper in Skip Feed mode is 590 mm, 23.2".
When you use paper longer than 447 mm, 17.5", completed prints will not be
delivered to the paper delivery table properly, so receive them by hand.
1
Set your originals on the expo-
sure glass or in the optional
document feeder.
2
Make sure that the Master Mak-
ing indicator is lit and then press
the Start key. Check the image
position of the trial or proof print.
If the image position is not correct,
adjust it using the Image Position
keys (
See page 21) or the side
plate fine adjusting dial. (
22.)
3
While pressing the Skip Feed
key, select the number of rota-
tions of the drum while one sheet
of paper is fed, using the Num-
ber key.
You can select from 1 to 9 rotations.
The beeper sounds after you set the
number of rotations.
71
See page
Advertisement
Table of Contents
