Table of Contents
Advertisement
OPERATION NOTES
The outer portion of the image might not be printed under low temperature. In
this case, increase the room temperature or slow the printing speed down to
step 1 or 2.
When you use originals with screened image in Letter mode, stripe patterns
might appear on the prints. In this case, make masters in Letter/Photo mode.
When you use originals with light lettering, edges of the letters may be printed
clearly and the inside of the letters may be light. In this case, increase the
image density.
When you use originals of fine letters, letters on prints may be skipped. In this
case, increase the image density or use Letter mode.
Since some parts of the machine are supplied with high voltage, touch only the
parts specified in this manual.
Do not spill liquid on the machine.
When removing the drum unit from the machine, be careful not to let the drum
unit fall.
Always turn the machine off when you have finished printing for the day.
If you clean rubber parts with benzine, wipe them with a dry cloth afterwards.
While printing, do not turn off the main switch.
While printing, do not unplug the power cord.
While printing, do not open the door or covers.
While printing, do not move the machine.
Open and close the door and covers softly.
Do not modify or replace any parts other than the ones specified in this manual.
Do not operate the machine without covers. You might get your fingers caught
in the machine, or the machine might be damaged because, for example, dust
or the like might get inside.
Since some parts of the machine are sharp and might cause injury, touch only
the parts specified in this manual.
159
Advertisement
Table of Contents
