Table of Contents
Advertisement
2. Remove the two screws that secure the pilot shield
to the burner bracket and remove the two screws
that secure the pilot assembly to the burner bracket.
Remove the one screw that secures the burner bracket
to the valve plate. See Figure 9.2. Gently push the
pilot assembly backwards to allow for the burner to be
removed.
3. Remove the screw that secures the burner bracket to
the valve plate. See Figure 9.2.
4. Slide burner assembly to the left to disengage the
burner tube from the orifice. Remove the burner from
the appliance.
5. Remove the nine screws around the perimeter of the
valve plate that secure valve plate to the appliance.
See Figure 9.3.
6. Lift up on the plate assembly. Ensure the gas ball valve
is turned off. Disconnect the ball valve assembly from
the gas valve by loosening the compression fitting
located on the left side of the gas valve.
7. Prior to removing valve assembly for service,
disconnect the pilot wires from the ignition module.
8. Upon completion of service, reverse steps 1-7. If the
valve plate gasket is damaged, replace the gasket
prior to reinstallation of valve plate assembly.
REMOVE PILOT SCREWS
REMOVE BURNER SCREW
Figure 9.2 Burner Removal
50
Majestic • JADE32IN, JADE42IN, JADE42IL Installation Manual • 2491-986 Rev. L • 4/19
REMOVE 9 SCREWS
Figure 9.3 Remove Valve Plate
Note: Install the gas supply line in accordance with local
codes, if any. If not, follow ANSI 223.1. Installation should
be done by a qualified installer approved and/or licensed
as required by the locality. (In the Commonwealth of
Massachusetts installation must be performed by a
licensed plumber or gas fitter).
Note: A listed (and Commonwealth of Massachusetts ap-
proved) 1/2 in. (13 mm) T-handle manual shut-off valve
and flexible gas connector are connected to the 1/2 in. (13
mm) control valve inlet.
• If substituting for these components, please consult
local codes for compliance.
Valve Pressure Taps
The pressure taps are accessible by removing the lower
panel prior to finishing material installation. There is
limited access to the pressure taps after finishing material
installation. Remove glass assembly and utilize an
appropriate sized screwdriver.
Advertisement
Table of Contents
