Table of Contents
Advertisement
Chapter 4 Modes
Table 20 Menu: AP Mode (continued)
LINK
Logs
Tools
Sys OP Mode
Language
4.4 Setting your NBG-418N to Universal Repeater Mode
Connect your computer to the LAN port of the NBG-418N.
1
The default LAN IP address of the NBG-418N is 192.168.1.1 in router mode (192.168.1.2 by default
2
in non-router mode). In router mode, the NBG-418N can assign your computer an IP address, so
you must set your computer to get an IP address automatically (computer factory default) or give it
a fixed IP address in the range between 192.168.1.3 and 192.168.1.254.
After you've set your computer's IP address, open a web browser such as Internet Explorer and
3
type the IP address of the NBG-418N as the web address in your web browser.
Log into the Web Configurator. See the
4
Go to Maintenance > Sys OP Mode > General and select Universal Repeater.
5
Figure 33 Maintenance > Sys OP Mode > Universal Repeater
A pop-up window window appears providing information on this mode. Click OK in the pop-up
6
message window. Click Apply. Your NBG-418N is now in Universal Repeater mode.
48
TAB
FUNCTION
View Log
Use this screen to view the logs for the categories that you selected.
Firmware
Use this screen to upload firmware to your NBG-418N.
Configuration
Use this screen to backup and restore the configuration or reset the
factory defaults to your NBG-418N.
Restart
This screen allows you to reboot the NBG-418N without turning the power
off.
General
This screen allows you to select the device operation mode: Router,
Access Point, Client Bridge or Universal Repeater.
Language
This screen allows you to select the language you prefer.
Chapter 2 on page 17
for instructions on how to do this.
Advertisement
Table of Contents
