Status Screen (Client Bridge Mode) - ZyXEL Communications BG-418N v1 User Manual

Note: Wait while the NBG-418N restarts, then log in to the Web Configurator again.

4.5.1 Status Screen (Client Bridge Mode)

Click on Status. The screen below shows the status screen in Client Bridge Mode.
Figure 37 Status Screen (Client Bridge Mode)
The following table describes the labels shown in the Status screen.
Table 23 Status Screen (Client Bridge Mode)
LABEL
Device Information
System Name
Firmware Version
WLAN Information
- SSID
- Operating Channel
- Security Mode
- Connection Status
LAN Information
- MAC Address
- IP Address
- IP Subnet Mask
- DHCP
System Status
Operation Mode
System Up Time
DESCRIPTION
This is the System Name you enter in the Maintenance > System >
General screen. It is for identification purposes.
This is the current firmware version of the NBG-418N.
This is the name of the selected AP that the NBG-418N is associating with.
This shows the channel that is used to connect to the selected AP.
This shows the wireless security the NBG-418N is using to connect to the AP.
This shows whether the NBG-418N is currently associated with the selected AP.
This shows the LAN Ethernet adapter MAC Address of your device.
This shows the LAN port's IP address.
This shows the LAN port's subnet mask.
This shows the LAN port's DHCP role - None.
This field shows the device operation mode: Router, Access Point, Client
Bridge or Universal Repeater.
This is the total time the NBG-418N has been on.
Chapter 4 Modes
53