Resetting The Nwa; Methods Of Restoring Factory-Defaults - ZyXEL Communications NWA1120 Series User Manual

2.3 Resetting the NWA

If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the rear panel of the NWA. This replaces the current configuration file with the factory-
default configuration file. This means that you will lose all the settings you previously configured.
The password will be reset to "1234".
Figure 9 The RESET Button

2.3.1 Methods of Restoring Factory-Defaults

You can erase the current configuration and restore factory defaults in two ways:
Use the RESET button to upload the default configuration file. Hold this button in for about 3
seconds (the light will begin to blink). Use this method for cases when the password or IP address
of the NWA is not known.
Use the web configurator to restore defaults (refer to
NWA1120 Series User's Guide
Chapter 2 Introducing the Web Configurator
Section 11.8 on page 120).
21