Resetting The Nwa/Wac; Getting More Troubleshooting Help - ZyXEL Communications NWA5000 SERIES User Manual

• Detach the WAC6500 series indoor AP from the mounting bracket.

20.6 Resetting the NWA/WAC

If you cannot access the NWA/WAC by any method, try restarting it by turning the power off and
then on again. If you still cannot access the NWA/WAC by any method or you forget the
administrator password(s), you can reset the NWA/WAC to its factory-default settings. Any
configuration files or shell scripts that you saved on the NWA/WAC should still be available
afterwards.
Use the following procedure to reset the NWA/WAC to its factory-default settings. This overwrites
the settings in the startup-config.conf file with the settings in the system-default.conf file.
Note: This procedure removes the current configuration.
Make sure the Power LED is on and not blinking.
1
Press the RESET button and hold it until the Power LED begins to blink. (This usually takes about
2
ten seconds.)
Release the RESET button, and wait for the NWA/WAC to restart.
3
You should be able to access the NWA/WAC using the default settings.

20.7 Getting More Troubleshooting Help

Search for support information for your model at www.zyxel.com for more troubleshooting
suggestions.
Chapter 20 Troubleshooting
NWA5000 / WAC6000 Series User's Guide
194