Sliding Table Parallel Adjustment - Grizzly G0623X Owner's Manual

Sliding Table Parallel
Adjustment
The table is calibrated at the factory, but can be
adjusted slightly if it is not parallel to the blade.
Tools Needed:
Felt Tip Pen ........................................................1
90° Square .........................................................1
Precise Measuring Tool ......................................1
Wrench 17mm ....................................................1
Hex Wrench 5mm ...............................................1
To adjust the sliding table parallel with the
main blade:
1.
DISCONNECT MACHINE FROM POWER!
2.
Move blade tilt to 0˚ (blade 90˚ to table), and
raise main blade up to maximum height.
3.
Mark one blade tooth with a felt-tip pen. This
will be your reference point when taking mea-
suring points, so you take them in the same
location each time.
4.
Move sliding table all the way back, and mea-
sure distance "A" in Figure 139, between
marked tooth and edge of miter slot.
Blade
Marked Tooth
B
Figure 139. Measuring distance between table
and blade.
Model G0623X/G0623X3 (Mfd. Since 05/22)
Qty
Marked Tooth
Miter Slot
A
5. Rotate blade 180°, move sliding table all the
way forward, and measure distance between
"B" in Figure 139.
6. Note difference between the two positions.
— If the gap is the same on both sides or the
difference is 0.004" or less, no adjustments
to the table parallelism need to be made.
— If the difference is greater than 0.004",
then the sliding table parallelism must be
adjusted. Proceed to Step 7.
7.
Loosen sliding table mounting nuts (see
Figure 140) at both mounting locations.
Table
Mounting Nuts
Figure 140. Table parallelism adjustment
controls.
8. At side of the table that needs to move,
loosen hex nut on parallel adjustment bolt.
9. Slowly rotate parallel adjustment bolt (see
Figure 140) as necessary to move table. If
you move adjustment bolt away from table,
push table against bolt before proceeding.
10. Tighten hex nut on parallel adjustment bolt to
secure it in place, then tighten table mounting
nuts. Repeat Steps 4–6 as necessary until
sliding table is parallel with blade.
Parallel
Adjustment Bolt
-73-