G0623X3 440V
Voltage Conversion
The Model G0623X3 is prewired for 220V 3-phase
operation, but can be rewired for 440V operation.
To complete this conversion procedure, you must
buy a 440V magnetic switch and rewire the motor
for 440V operation. The 440V magnetic switch,
Part P0623X30346A, can be purchased from
Grizzly by calling 1-800-523-4777.
This rewiring job must be inspected by a quali-
fied electrician before the saw is connected to the
power source. Also, the junction box on the motor
can be accessed easier for rewiring if the blade is
moved to 0˚ (90˚ to table) before beginning.
-16-
To rewire the machine for 440V operation:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove cover of magnetic switch.
3.
Disconnect all wires from incoming power
cords.
4.
Remove magnetic switch and install new
magnetic switch in same manner as old
switch was installed. Refer to wiring diagram
on Page 80 if you need help remembering
where wires are attached.
5.
Remove cabinet cover from back of machine.
6.
Rewire motor to 440V as shown in diagram
on Page 80.
7.
Replace junction box cover, cabinet door
cover, and magnetic switch cover.
Model G0623X/G0623X3 (Mfd. Since 05/22)