Grizzly G0623X Owner's Manual page 37

To test run the machine:
1. Put on safety glasses, make sure any
bystanders are out of the way, and that all
tools have been removed from saw.
2.
Push in, then rotate both STOP buttons
clockwise until they pop out. This resets
switch so machine can be started.
3.
Press ON button. Blades should start up and
run smoothly without any problems. If any
problems occur, immediately press the STOP
button.
4.
Press STOP button. As main blade comes to
a stop, watch the direction that it spins.
— The main blade should spin clockwise if you
are standing at the front of the machine. If
this is true, continue to Step 5.
— If the main blade rotates counterclock-
wise, disconnect the saw from power and
exchange wires R & T in the power con-
nection box to change the motor direction
(Model G0623X3 only). After exchanging
the wires and closing the power connection
box, connect the saw to power, and repeat
Steps 3–4.
5.
Make sure STOP button is pushed in, then
press ON button.
— The saw should NOT start if the disabling
feature on the STOP button is working cor-
rectly. If this is true, continue to Step 6.
— If the saw DOES start when the STOP but-
ton is pushed in, then the safety feature
on the STOP button is not working cor-
rectly. Call Tech Support for advice before
proceeding any further with the test run or
machine operations.
Model G0623X/G0623X3 (Mfd. Since 05/22)
6. Rotate STOP button clockwise so it pops out,
then repeat Step 5 on rear STOP button (see
Figure 52).
Rear
STOP
Button
Figure 52. Rear STOP button location.
7. DISCONNECT MACHINE FROM POWER!
8. Move sliding table all the way forward, then
open orange blade guard (refer to Page 43
for details on accessing and opening blade
guard). Opening blade guard triggers limit
switch.
9. Connect saw to power source.
10. (During this step, be prepared to immediately
press STOP button if blades start operating.)
Press ON button.
—If the blade guard limit switch functions cor-
rectly, the machine will not start. If this is
true, continue to Step 10.
—If the machine starts during this test, the
limit switch is NOT functioning correctly.
Disconnect the saw from power, and call
Tech Support for advice before proceeding
any further with the test run or machine
operations.
11. Close orange blade guard and move sliding
table back to center of machine.
Power
Connection Box
-35-