Grizzly G0623X Owner's Manual page 29

Note: The fence should slide smoothly on the
rail; if it doesn't, remove the fence base and
adjust the spring pressure plate mounting
position on the fence base (see Figure 23).
13. Thread rip fence lever into fence base
(Figure 23), tighten hex nut against rip fence
base to keep lever in place.
Spring Pressure
Plate
Rip Fence
Lever
Figure 23. Location of spring pressure plate for
fence slide adjustments.
14. Slide rip fence on fence base T-bar as shown
in Figure 24. Use two lock levers on opposite
side of fence base to secure fence in position.
Rip Fence
Figure 24. Rip fence installed on fence base.
Model G0623X/G0623X3 (Mfd. Since 05/22)
T-Bar
Lock Levers
15. Place 12mm flat washer on crosscut table
lock lever, then insert it through crosscut
fence and thread M12-1.75 T-nut onto end
approximately two turns.
16. Align T-slot bars and T-nuts on crosscut table
with T-slot in face of sliding table, then slide
crosscut table into position on sliding table
and tighten crosscut table lock lever (see
Figure 25).
T-Slot
Figure 25. Crosscut table installation.
17. Place crosscut table support leg on extension
arm, and attach it to crosscut table with four
M6-1 x 16 cap screws, 6mm lock washers,
and 6mm flat washers (see Figure 26).
Extension
Arm
Figure 26. Support leg installed.
Lock Lever
Attachment
Location
Support Leg
-27-