Grizzly G0623X Owner's Manual page 30

18. Insert two crosscut brace knobs with 8mm
flat washers through crosscut table, then
thread square nuts onto ends of knob threads
(Figure 27, A). Slide T-slot in support bar
over both T-nuts, and tighten knobs (Figure
27, B).
Support
Square Nut
Bar
B
Flat Washer
8mm
Knob
M8-1.25 x 50
Figure 27. Installing support bar on crosscut
table.
19. Slide pivot stud assembly and M8-1.25 x 60
T-bolt into crosscut fence T-slot, as shown in
Figure 28.
20. Align T-bolt and pivot stud with crosscut table
insertion points (see Figure 28), and install
fence on table.
Pivot Stud
Assembly
T-Bolt M8-1.25 x 60
Figure 28. Pivot stud and T-bolt installed in
crosscut fence.
21. Thread M8-1.25 knob with an 8mm flat
washer onto bottom of T-bolt from underside
of table.
-28-
Crosscut
M8-1.25
Table
A
...to T-bolt
Flat Washer
8mm
Knob
M8-1.25 x 55
22. Hold crosscut fence against positive stop
bolt, shown in Figure 29, then tighten knob
underneath crosscut table to lock crosscut
fence in position.
Note: This positive stop bolt can be fine-
tuned later to ensure that the crosscut fence
is square to the blade.
Figure 29. Use positive stop bolt to position the
crosscut fence.
23. Install flip stops in T-slot on crosscut fence,
as shown in Figure 30, and use crosscut
fence lock knob to secure extendable end of
fence in position.
Flip Stops
Crosscut Fence Lock Knob
Figure 30. Flip stops installed on crosscut fence.
Model G0623X/G0623X3 (Mfd. Since 05/22)
Positive
Stop Bolt
M8-1.25 x 25