Grizzly G0623X Owner's Manual page 31

24. Remove shipping brace from sliding table
(see Figure 31), and install fixed table end
cover over fixed part of sliding table end,
then install end cover w/bracket over sliding
table end using premounted hardware (see
Figures 31–32).
Shipping
Brace
Figure 31. Fixed table components location.
Figure 32. Sliding table end cover installed.
25. Attach sliding table handle, as shown in
Figure 33, with two button head screws and
flat washers, using premounted hardware.
Figure 33. Sliding table handle attached to end
of sliding table.
Model G0623X/G0623X3 (Mfd. Since 05/22)
Fixed Table
End Cover
End Cover
w/Bracket
Button Head
Cap Screws
26. Verify that two M5-.8 x 25 button head screws
are threaded tightly into magnetic switch
mounting bracket. Loosen two attached
M5-.8 flange nuts for clearance if needed,
then slide mounting bracket and switch into
sliding table base T-slot.
27. Adjust switch location, then tighten M5-.8
flange nuts to secure (see Figure 34).
Magnetic
Switch
Figure 34. Magnetic switch attached with flange
nuts adjusts for location.
28. Thread feet fully into bottom of support legs.
DO NOT remove hex nuts pre-installed on
bottom of feet. They will be used to secure
feet after legs are installed.
29. Thread two M8-1.25 x 20 cap screws and
8mm lock washers through each support
leg and part way into T-slot plates for legs,
slide T-slot plates into both ends of sliding
table base, and tighten cap screws (see
Figure 35).
Figure 35. Support leg installed (1 of 2 shown).
Support Leg
-29-