Grizzly G0623X Owner's Manual page 32

30. Adjust feet downward so they press against
floor, then tighten hex nuts up against sup-
port leg so feet are locked in place.
31. Open cabinet door and remove motor ship-
ping brace shown in Figure 36.
Figure 36. Motor shipping brace.
32. Tilt blade assembly to 0˚, then slide sliding
table forward all the way until you can open
lower blade guard cover and access blade
arbors.
The Model G0623X and G0623X3 do not
ship with a 10" main blade. See Blade
Requirements/Blade Selection beginning
on Page 41 when purchasing main blade.
33. Insert arbor lock tool into hole shown in
Figure 37, rotate arbor until arbor lock tool
seats, then install main blade according to
Step 7 of Changing Main Blade on Page 43.
IMPORTANT: There MUST be an arbor
flange on both sides of blade.
Arbor Lock Tool
Figure 37. Installing main blade.
-30-
34. Insert arbor lock tool into hole shown in
Figure 38, rotate arbor until arbor lock tool
seats, then install scoring blade, using arbor
wrench. There MUST be an arbor flange on
both sides of blade.
Arbor
Lock
Tool
Figure 38. Installing scoring blade.
35. Install splitter/riving knife (see Figure 39).
DO NOT tighten mounting bolt at this time.
Figure 39. Installing splitter/riving knife.
36. Adjust splitter/riving knife approximately
away from main blade, using a
hex wrench as guide (see Figure 40).
Figure 40. Adjusting the riving knife spacing.
Model G0623X/G0623X3 (Mfd. Since 05/22)
⁄ "
1
8
⁄ " or 3mm
1
8