Set up, install, and configure
Printer model
XC9335
1
Needs an installed fax card. For more information, contact the place where you purchased the printer.
2
Needs a subscription. For more information, go to
you purchased the printer.
3
Needs an installed license bundle. For more information, contact the place where you purchased the printer.
Setting up the fax function using analog fax
Notes:
•
A fax card must be installed for the printer to use analog fax.
•
Some connection methods are applicable only in some countries or regions.
•
If the fax function is enabled and not fully set up, then the indicator light may blink red.
•
If you do not have a TCP/IP environment, then use the control panel to set up fax.
Warning—Potential Damage: To avoid loss of data or printer malfunction, do not touch cables or the printer
in the area shown while actively sending or receiving a fax.
Using the Settings menu in the printer
1
From the home screen, touch Settings > Fax > Fax Setup > General Fax Settings.
2
Configure the settings.
Using the Embedded Web Server
1
Open a web browser, and then type the printer IP address in the address field.
Notes:
•
View the printer IP address on the home screen. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
1
Analog fax
2
etherFAX
https://www.etherfax.net/lexmark
Fax server
Fax over IP (FoIP)
or contact the place where
40
3