Table of Contents
Advertisement
7.0
SPOTTING AND INSTALLATION
Note: Read and understand the entire manual before
attempting setup or operation.
1.
Finish uncrating the saw and inspect for damage. Should
any damage have occurred, immediately contact your
local distributor and shipping agent.
2.
Remove the four (4) nuts and washers holding the band
saw to the pallet.
3.
Use the four lifting rings to lift the band saw to its permanent
location. See section 6.0. For best performance, the
machine should be located on a solid and level concrete
foundation. Allow room for servicing and for moving large
stock around the band saw when deciding a location for
the machine.
4.
Attach the base frame cover (Fig. 1). Install the M12 nuts
(4pcs). Install the hex head screws and flat washers into
the saw base, then tighten using a 19mm wrench.
A
5.
To level the machine, place a level on the table and
observe in both directions.
6. Anchoring the machine to the concrete floor is highly
advised (B, Fig. 1A).
7. An alternative to anchoring is to use metal plates or
shims. Use a metal shim under each leveling bolt (Fig.
1A).
8.
To level, adjust the bolts on each corner (A, Fig. 1) until
the unit is level in both directions. Tighten the jam nuts
against the mounting foot.
EVTBS16V
891200_EVTBS16V Tilting Band Saw_Edition 1.indd 11
891200_EVTBS16V Tilting Band Saw_Edition 1.indd 11
9.
Remove the red shipping bracket (C, Fig. 2).
10. Loosen the two (2) set screws underneath the table
preventing the carriage from sliding during shipment (D,
Fig. 1
Fig. 3). Loosen these with a 6mm hex wrench.
11. Remove any preservatives from exposed metal surfaces
with a cleaner/degreaser. Do not use gasoline, paint
thinner, or any cellulose-based product, as these will
damage painted surfaces.
Fig. 1A
Fig. 2
Fig. 3
11
5/10/22 10:22 AM
5/10/22 10:22 AM
Advertisement
Table of Contents
