Remaining Hazards; Machine Specifications; Technical Data; Noise Emission - Jet JBS12-M Operating Instructions Manual

Do not remove chips and workpiece parts until the machine is
at a complete standstill.
Do not stand on the machine.
Connection and repair work on the electrical installation may
be carried out by a qualified electrician only.
Have a damaged or worn cord replaced immediately.
Make all machine adjustments or maintenance with the
machine unplugged from the power source.
Remove defective saw blades immediately.

3.3 Remaining hazards

When using the machine according to regulations some
remaining hazards may still exist
The moving saw blade in the work area can cause injury.
Broken saw blades can cause injuries.
Thrown workpieces can lead to injury
Wood chips and sawdust can be health hazards. Be sure to
wear personal protection gear such as safety goggles ear- and
dust protection.
Use a suitable dust exhaust system.
The use of incorrect mains supply or a damaged power cord
can lead to injuries caused by electricity.

4. Machine specifications

4.1 Technical data

Wheel diameter
Cutting width
Cutting height
Sawblade length
Blade width
Blade thickness
Cutting speed
Machine Table(Lx W)
Table tilting range
Working height with stand
Dust port diameter
Overall without stand
(WxDxH)
Weight without stand
315 mm
max 305 mm
max 180 mm
2240 mm
6 - 15 mm
0,4 – 0,6 mm
370 or 800 m/min
400x480 mm
0° to 45°
1000mm
100mm
600 x 805 x1320mm
62 kg
Overall with stand
(WxDxH)
Weight with stand
Mains
Motor power
Reference current
Extension cord (H07RN-F):
Installation fuse protection

4.2 Noise emission

Determined according to EN 1807
(Inspection tolerance 3 dB)
Workpiece beech:
T=30mm, L=1500mm, moisture 8,5%
Acoustic power level
(according to EN ISO 3746):
Idling
Operating
Acoustic pressure level
(EN ISO 11202):
Idling
Operating
The specified values are emission levels and are not necessarily
to be seen as safe operating levels. Although there is a
correlation between emission and imission levels, these do not
constitute a basis for determining the necessity of additional
safety measures. Workplace conditions which could influence
the noise imission level include the duration of resonance,
spatial particulars, other noise sources etc. For example, the
number of machines and other work being performed. The
permissible workplace levels can vary from country to country.
This information is intended to allow the user to make a better
estimation of the hazards and risks involved.

4.3 Dust emission

The band saw JBS-12 has been dust emission inspected.
At an air velocity of 20 m/s on the dust port dia 100mm:
Vacuum pressure
Volume flow
The machine meets a workplace dust emission limit of 2 mg/m³.
4.4 Content of delivery
Open stand
Machine table
Fence
Fence support rails
Mitre gauge
Dust port 100mm
Assembly bag
Saw blade 13 mm
Operating manual
Spare parts list

5. Transport and start up

5.1 Transport and installation

For transport use a forklift or hand trolley. Make sure the
machine does not tip or fall off during transport.
6
655 x 915 x1860mm
68 kg
1~230V, 50Hz
800W
3,5 A
3x1,5mm²
10 A
LwA 85,0 dB(A)
LwA 96,4 dB(A)
LpA 72,6 dB(A)
LpA 83,4 dB(A)
1250 Pa
565 m³/h