Transport And Start Up; Transport And Installation; Assembly - Jet JWBS-14Q Operating Instructions Manual

Machine table
Fence
Fence support rails
Parallel cutting device
Mitre gauge
Dust port 100mm
Assembly bag
Saw blade 10 mm
Operating manual
Spare parts list

5. Transport and start up

5.1 Transport and installation

For transport use a forklift or hand trolley. Make sure the
machine does not tip or fall off during transport.
The machine is designed to operate in closed rooms and
must be placed stable on firm and levelled ground.
The machine can be bolted down if required.
For packing reasons the machine is not completely
assembled.

5.2 Assembly

If you notice any transport damage while unpacking, notify
your supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly manner.
Clean all rust protected surfaces with a mild solvent.
Mount the machine table to the trunions and attach the lock
knobs (A, Fig 2).
Set the table to be square to the sawblade and reference the
table stop (B) and the tilting scale (D).
Attach the support rails (G, Fig 3) to the machine table with 4
hex cap screws, 4 spring washers and 4 washers and align
them parallel to the table surface.
Fig 2
Attach the guide rail (H) with 5 hex cap screws, 5 spring
washers and 5washers.
Place the fence assembly (B, Fig 4) on the guide rail and align
the fence profile (A) to be parallel to the mitre groove in the
table.
Move the fence assembly flush to the sawblade and set the
pointer (C) to zero.
Check the clearance between the table and the fence. The
gap should be appr. 1mm. Use the support rails and the rear
glide piece (E, Fig 5) to adjust.
Fig 3
Fig 4
Fig 5