Table of Contents
Advertisement
2.0
IMPORTANT SAFETY INSTRUCTIONS
Read and understand the entire instruction manual before operating machine.
This band saw is designed and intended for use by properly trained and experienced personnel only. If you are not
familiar with the proper and safe operation of a band saw, do not use until proper training and knowledge has been
obtained.
WARNING – To reduce risk of injury:
1.
Read and understand the warnings posted on the machine and in this manual. Failure to comply with all of these warnings
may cause serious injury.
2.
Replace the warning labels if they become obscured or removed.
3.
Do not use this band saw for other than its intended use. If used for other purposes, JET
warranty and holds itself harmless from any injury that may result from that use.
4.
Always wear approved safety glasses/face shields while using this band saw. Everyday eyeglasses only have impact resistant
lenses; they are not safety glasses.
5.
Before operating this band saw, remove your tie, rings, watches and other jewelry, and roll sleeves up past the elbows. Remove
all loose clothing and confine long hair. Non-slip footwear or anti-skid floor strips are recommended. Do not wear gloves.
6.
Wear ear protectors (plugs or muffs) during extended periods of operation.
7.
Do not operate this machine while tired or under the influence of drugs, alcohol or any medication.
8.
Make certain the switch is in the OFF position before connecting the machine to the power supply.
9.
Make certain the machine is properly grounded.
10. Make all machine adjustments or maintenance with the machine unplugged from the power source.
11. Remove adjusting keys and wrenches. Form a habit of checking to see that keys and adjusting wrenches are removed from
the machine before turning it on.
12. Avoid contact with coolant, especially guarding your eyes.
13. Always keep hands and fingers away from the blade when the machine is running.
14. Never hand hold the material. Always use the vise and clamp it securely.
15. Deburr sharp edges before handling or cutting.
16. Always provide adequate support for long and heavy material.
17. Keep safety guards in place at all times when the machine is in use. If removed for maintenance purposes, use extreme
caution and replace the guards immediately after maintenance is complete.
18. Check damaged parts. Before further use of the machine, a guard or other part that is damaged should be carefully checked
to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
19. Do not use power tools in damp/wet locations or other dangerous environments. Do not expose them to rain. Keep work area
well lit. Provide for adequate space surrounding the work area and non-glare overhead lighting.
20. Keep the floor around the machine clean and free of scrap material, oil and grease.
21. Keep visitors a safe distance from the work area. Keep children away. Workshop should be childproof; padlocks, master switches,
remove starter keys.
EVTBS16V
891200_EVTBS16V Tilting Band Saw_Edition 1.indd 3
891200_EVTBS16V Tilting Band Saw_Edition 1.indd 3
, disclaims any real or implied
®
5/10/22 10:22 AM
5/10/22 10:22 AM
3
Advertisement
Table of Contents
