Jet ELITE EVTBS16V-230 Operating Instructions And Parts Manual page 4

22. Give your work your undivided attention. Looking around, carrying on a conversation and "horse-play" are careless acts that
can result in serious injury.
23. Maintain a balanced stance at all times so that you do not fall or lean against the blade or other moving parts. Do not overreach
or use excessive force to perform any machine operation.
24. Use the right tool at the correct speed and feed rate. Do not force a tool or attachment to do a job for which it was not designed.
The right tool will do the job better and more safely.
25. Use recommended accessories; improper accessories may be hazardous.
26. Maintain tools with care. Keep the blade sharp and clean for the best and safest performance. Follow instructions for lubricating
and changing accessories.
27. Maintain proper adjustment of blade tension, blade guides and thrust bearings.
28. Turn off the machine and disconnect from power before cleaning. Use a brush to remove chips or debris — do not use your
hands.
29. Do not stand on the machine. Serious injury could occur if the machine tips over.
30. Never leave the machine running unattended. Turn the power off and do not leave the machine until it comes to a complete
stop.
31. Be sure that the blade is not in contact with the workpiece when the motor is started. The motor shall be started and you should
allow the saw to come up to full speed before bringing the saw blade into contact with the workpiece.
32. Adjust upper guide to clear workpiece. Hold workpiece firmly against the table.
33. Direction of feed — feed work into a blade or cutter against the direction of rotation of the blade or cutter only.
34. Installation work and electrical wiring must be done by a qualified electrician in accordance with all applicable codes and
standards.
35. Do not remove jammed pieces until blade has stopped.
36. Do not bypass or defeat safety interlock systems.
WARNING: This product can expose you to chemicals including titanium dioxide which is known to the State of
California to cause cancer, and lead which is known to the State of California to cause cancer and birth defects or other
reproductive harm. For more information go to http://www.p65warnings.ca.gov.
WARNING: Some dust, fumes and gases created by power sanding, sawing, grinding, drilling, welding and other
construction activities contain chemicals known to the State of California to cause cancer and birth defects or other
reproductive harm. Some examples of these chemicals are:
• lead from lead based paint
• crystalline silica from bricks, cement and other masonry products
• arsenic and chromium from chemically treated lumber
Your risk of exposure varies, depending on how often you do this type of work. To reduce your exposure to these chemicals,
work in a well-ventilated area and work with approved safety equipment, such as dust masks that are specifically designed
to filter out microscopic particles. For more information go to http://www.p65warnings.ca.gov/ and http://www.p65warnings.
ca.gov/wood.
4
891200_EVTBS16V Tilting Band Saw_Edition 1.indd 4 891200_EVTBS16V Tilting Band Saw_Edition 1.indd 4
Vertical Tilting Band Saw
5/10/22 10:22 AM 5/10/22 10:22 AM